length of counable point on a spike deer

The overall quality of antlers can be decided with this counting point method. And so, the points start to upsurge as they become huger plus wider.

There’s more development with time as well as feature acquiring with each new shedding. When you deal with younger bucks, the whole counting point things become a comfortable deal to do. Here’s How to Count Points on a Buck Using Simple Method. And so, let’s have a deep discussion on how to count points on a buck with today’s special guide. However, the whole points counting thing on buck can sound complex for some people. And so, several conversations on buck having how many points come to life. This is the only time of the whole year when males get to demonstrate their antlers skill. If extra points along the beam tops create obvious mis-matches from side to side, these may be abnormal.During the rutting season, it’s common to have deer everywhere around you. Look at both sides of the rack and match up points by their location. The final point count for each antler includes all measurable points, normal and abnormal, plus the main beam tip. On white-tailed deer antlers, all normal points project from the top, not the sides or bottom, of the main beam and they may not branch from other points. In this instance, repeat the baseline process but the point will serve as the “main beam” and the abnormal point will serve as the “point.” Also, keep in mind that you may have to repeat this process for abnormal points that occur on normal points. In addition, for small points, a proper baseline is important because it will allow you to determine whether or not the point meets the definition of a point. With baselines established, use the flexible steel cable and measure from the tips of the points to their respective baselines.Įstablishing the correct baseline is very important because you do not want to under-estimate point length, but you also don’t want to over-estimate. You have now established the baseline for this point, but you must repeat this process in order to establish the baselines for every other point. Using a pencil, draw a line below the cable. Holding the cable in place, you can see where the antler material from the main beam intersects material from the antler point. Hold the cable on top of the main beam about an inch from the point in question and run it around the point to the top of the main beam on the other side of the point. With all of that said, let’s establish baselines. If there are extra points along the tops of the main beams, such as between “normally” spaced points (compare to the other antler), this will create obvious mis-matches from the left side to the right side and these may be considered abnormal points (antlers with numerous abnormal points will most likely be scored as non-typical bucks). Points that originate from the sides or bottoms of the main beams are obviously abnormal. The final point count for each antler includes all measurable points, normal and abnormal, plus remember the main beam tips. All normal points project from the top, not the sides or bottom, of the main beam and normal points may not branch from other points. To do this, dig into your scoring equipment and find your flexible steel cable.īefore we get into establishing baselines, remember that each point must be classified as either normal or abnormal. Determine the baseline at the base of each point along the main beam. To determine how many normal and abnormal points your trophy has, the next step is to establish baselines so that “possible points” can be identified and all point lengths can be obtained. To properly measure a point, you must first know the definition of a scorable point. The biggest mistake most people make when scoring a whitetail’s antlers is inaccurately measuring the lengths of the points. Scoring your buck using the Boone & Crockett Method is not difficult, but it does require some time and effort.

Length of counable point on a spike deer